Skip to content

Draw a network from scratch

Every SWMM element can be drawn directly on the map.

Pick a tool from the drawing palette on the left edge of the map and click the map. Each tool also has a single-key shortcut, shown when you hover it.

Nodes: junction, outfall, storage, divider. Links: conduit, pump, orifice, weir, outlet. Also rain gages and subcatchments.

A newly placed node gets its ground elevation sampled automatically from world terrain data, so you are not starting from zero. Check it against your own levels before relying on it - a global DEM is good for slope and drainage direction, not for an invert.

Click the upstream node, then the downstream node. Direction matters: it defines the assumed direction of positive flow.

Links can bend. Click a link to select it, then drag its vertices, drag a midpoint handle to create one, or double-click a vertex to remove it. Vertices are geometry only - conduit length is an explicit property, so bending a pipe does not silently change its hydraulics.

Draw a polygon and set its area, imperviousness, width and slope, then point its outlet at a node or at another subcatchment for cascading runoff.

Select anything and the Properties panel shows its full attributes, editable in place. Numeric fields commit shortly after you stop typing, so every keystroke is not a separate undo step.

For faster bulk work use Flex Tables: sort, search, and double-click a cell to edit.

Every edit is undoable with Ctrl/Cmd+Z, fifty levels deep.

Edits that change the hydraulics clear the existing results, because stale results beside an edited model are worse than no results. Moving a vertex does not, since conduit length is explicit.

Run Validate at any point. It reports disconnected nodes, conduits with no cross-section, links pointing at nodes that do not exist, references to deleted curves, patterns or time series, and more. Each issue has a locate link that selects the element and flies the map to it.