Street inlets and dual drainage
In an ordinary model, all the runoff from a subcatchment arrives at its outlet node. Reality is less generous: water runs along the gutter, and only what a grate can physically capture gets into the sewer. The rest carries on down the road.
Dual drainage models both paths - the surface and the pipe - so the inlet becomes the constraint it is in practice.
When it matters
Section titled “When it matters”Where the surface floods but the sewer has capacity. That combination is the signature of inlet capture being the limit, and a pipes-only model cannot show it - it will report the sewer coping while the street is under water.
Where flow runs past inlets to collect somewhere else. A sag in the road, or a low property, receives water shed from uphill inlets that were already at capacity. The bypass is the whole mechanism, and it does not exist in a model without inlets.
Where inlets are blocked. Leaves, silt, ice. A clogging percentage turns a maintenance question into a modelled one.
Setting it up
Section titled “Setting it up”-
Select the conduit that represents the road.
-
In its Properties, use + Add street inlet, then choose the receiving node - the sewer manhole the inlet drops into.
-
That does three things at once: the conduit’s cross-section becomes a STREET section carrying gutter flow, a standard combination grate and curb-opening inlet design is created, and an inlet-usage row links the two.
-
Adjust the street and inlet as needed: crown width, curb height, cross slope and road roughness on the street; number of inlets, clogging percentage and any flow cap on the usage.
The defaults describe a typical two-sided urban street - 4 percent cross slope, asphalt roughness, a roughly 0.9 m grate. They are a sensible start, not a substitute for the actual geometry.
How the two paths join
Section titled “How the two paths join”The street conduit conveys surface flow downhill. At each inlet, SWMM computes how much that inlet can capture given the approach flow, the grade and the geometry, sends the captured portion to the receiving node, and passes the remainder along the street to the next inlet.
Reading the result
Section titled “Reading the result”Look at the street conduit as well as the sewer. Depth on the street is depth on the road, and it is the number that tells you whether a carriageway is passable. Compare the flow captured at each inlet against what arrives: a series of inlets all running at their capture limit means the system is inlet-limited, and upsizing the pipe below them will change nothing.