Skip to content

Curves

A curve is a relationship between two quantities, given as a table of X/Y points. A pattern is a schedule against time; a curve is a physical relationship, and SWMM interpolates between the points you give it.

Open them at Model data ▸ Curves.

TypeXYUsed by
PumpDepth, head or volume (by type)FlowA pump link. Five sub-types
StorageDepthSurface areaA storage node
RatingHeadFlowAn outlet link
TidalHour of dayStageAn outfall with a TIDAL boundary
ShapeDepth / full depthWidth / full depthA custom conduit cross-section
DiversionInflowDiverted flowA flow divider
ControlController valueSettingA pump or regulator under a modulated rule
WeirHeadDischarge coefficientA weir whose coefficient varies with head

A depth-area curve is where most storage modelling goes wrong, because the error does not announce itself. Volume is the integral of area over depth, so an area that is too generous low down gives the basin volume it does not have, and the model will show attenuation that the real structure cannot deliver.

Two habits help. Include a point at depth 0 with the true base area, since SWMM extrapolates below the first point. And check the volume the curve implies against a hand calculation of the structure before trusting a result that depends on it.

The editor is an X/Y table with a live chart and the axis labels for the type you picked, so a curve entered the wrong way round is visible immediately. Import / paste takes rows copied from a spreadsheet or a CSV, one X/Y pair per line. Keep the X values increasing, with no repeats: SWMM rejects a curve whose points are out of sequence (error 171).

A curve is referenced by name. Renaming one that a pump or storage node already points at breaks the reference, and Validate reports it as a dangling reference rather than letting the run fail with an unexplained engine error.