Skip to content

Profile and HGL

The profile is the classic sewer drawing: pipe inverts stepping down a flow path, the ground surface above them, and after a run the hydraulic grade line showing where the water actually stands. It answers a question the map cannot - not which pipes surcharge, but why, and what the water level is doing along the whole route.

  1. Open Profile from the toolbar.

  2. Pick a start and an end node. The path between them is found automatically.

  3. Run the model if you have not already. Without results you get the geometry - inverts, barrels, manholes, ground line - which is useful on its own for checking a build.

The path follows any link type, not just conduits: orifices, weirs, pumps and outlets are all traversed. That matters on a real network, because a detention pond usually discharges through a weir or orifice rather than a pipe, and a path restricted to conduits would stop dead at the pond.

What you seeWhat it means
HGL inside the barrelFree-surface flow. The pipe has capacity in hand
HGL at the pipe soffitRunning full - at capacity, no freeboard
HGL above the soffitSurcharged. The pipe is pressurised and backing up
HGL above the ground lineFlooding. Water is out of the manhole at that node

The slope of the HGL is the hydraulic gradient, so a steep section is where head is being lost. A long flat HGL upstream of a constriction is backwater, and the constriction is at its downstream end, not where the flat section starts.

Diagnosing flooding. The map shows you a flooded node. The profile shows you the run of pipe that put it there.

Checking a design change. Draw the same path before and after upsizing, and the HGL drop is the benefit, in metres of head rather than a percentage.

Sanity-checking a new model. Adverse slopes, inverts above ground, and pipes that step the wrong way are obvious in profile and nearly invisible in plan. Worth one look along every main trunk before trusting a freshly built or imported network. The network trace checks find these systematically.