Skip to content

Transects

A transect is a surveyed cross-section of a natural channel: a set of station and elevation points, plus roughness. Assign one to a conduit with the IRREGULAR cross-section type and SWMM routes flow on the real shape of the watercourse rather than forcing it into a pipe or a trapezoid.

Open them at Model data ▸ Transects. The format is HEC-2, so a transect surveyed for a hydraulic study usually transfers without redrawing.

  • Station and elevation pairs, left to right looking downstream. Stations are distances across the section, not chainages along the channel.
  • Left and right bank stations, which split the section into left overbank, main channel and right overbank.
  • Three roughness values, one for each of those three parts.

This is what a transect gives you that a trapezoid cannot. A grassed or wooded floodplain is far rougher than the channel it flanks, so once flow goes overbank the effective roughness of the section changes. One Manning’s n across the whole width cannot express that, and it is usually the reason an out-of-bank result looks too fast.

A common starting set is around 0.03 for a clean main channel and 0.05 to 0.10 for vegetated overbank, but these are book values: local survey beats them.

The editor draws the section as you type, which catches the two common data faults at a glance: points entered right to left, so the section is mirrored, and a station or elevation column swapped, so the channel appears as a spike.

The same conduit still needs its own length and slope. A transect describes the shape of the section, not the fall along it.