Open channel and pipe design
Solves Manning’s equation for uniform (normal-depth) flow: give it a section, a slope, a roughness and a design flow, and it returns the depth that flow runs at and how much of the section’s capacity it uses. To size a section, change the dimensions until the capacity used is where you want it.
Sections
Section titled “Sections”Circular pipe, rectangular, trapezoidal and triangular channels. For each you set the
geometry, the longitudinal slope and Manning’s n, or Load from selected conduit to start
from a pipe already in the model.
What it reports
Section titled “What it reports”- Normal depth and critical depth for the design flow, and the critical slope.
- Velocity at normal depth.
- Full-flow capacity, and the share of it the design flow uses.
- Froude number and flow regime, so you know whether flow is sub- or supercritical.
Using it with a model
Section titled “Using it with a model”The tool is a calculator, not a model editor. Size the section here, then set the geometry on the conduit in the model and re-run - because the model accounts for backwater, storage and unsteady flow, none of which uniform-flow theory represents.
Uniform flow is a design starting point. Dynamic-wave routing is the check.