Water quality modelling
SWMM models pollutants as mass that accumulates on surfaces between storms and washes off during them.
The three mechanisms
Section titled “The three mechanisms”Build-up. Mass accumulates on each land use during dry weather, following a power, exponential or saturation function of the antecedent dry period. Long dry spells mean more available mass, which is why the first storm after a dry summer is often the worst.
Wash-off. Runoff mobilises that mass. Rate depends on runoff intensity, which is why concentration peaks early in a storm and then falls - the first flush.
Treatment. Removal at a node, expressed as a function or a fixed efficiency, for representing an interceptor, a settling tank or a treatment works.
Setting it up
Section titled “Setting it up”- Define pollutants - name, units (mg/L, ug/L or counts), rain and groundwater concentrations, and decay.
- Define land uses and give each one build-up and wash-off parameters.
- Assign land uses to subcatchments as percentage coverages.
- Optionally add treatment at nodes.
Any pollutant
Section titled “Any pollutant”The mechanism is generic, so it is not limited to conventional determinands. TSS, total phosphorus and lead are conventional; PFAS and other emerging contaminants are modelled the same way, given build-up and wash-off parameters.
Reading the results
Section titled “Reading the results”The pollutograph - concentration through time - tells you more than a peak value. Look for whether a first flush exists, how long elevated concentrations persist, and how that lines up with the flow hydrograph.
Load, the product of flow and concentration integrated over time, is what a receiving water actually experiences and what most consents are written against. A low concentration at high flow can be a larger load than the reverse.
Quality continuity is reported alongside flow continuity, and deserves the same scepticism: if it is poor, the loads are not trustworthy.