Skip to content

I&I and RDII

Rainfall-derived infiltration and inflow is rain that reaches the foul sewer through defects, illicit connections and improperly decommissioned surface drains. In many networks it is larger than the sanitary flow it sits on top of.

A flat percentage added to dry-weather flow does not respond to rainfall. During a storm it stays exactly where it was, which is the opposite of what real ingress does. It is also reported by the engine as sanitary flow, so it never appears as I&I in the water balance.

RDII solves both: it is driven by the rain gage, and the engine reports it on its own line.

SWMM models RDII with the RTK method. Each unit hydrograph has three response terms, and each term is a triangle:

ParameterMeaning
RFraction of rainfall on the sewershed that enters the sewer
THours from rainfall to the peak of the response
KRatio of recession time to time to peak

The three terms represent different physical routes:

  • Short - direct inflow through defects and cross-connections. Fast, sharp.
  • Medium - delayed interflow through the soil.
  • Long - slow groundwater infiltration, lasting days after the storm.

Select the node, open Properties, find RDII (rainfall-derived I&I) and press Add. Set the sewershed area draining to that node, then tune R, T and K for each term.

Defaults start deliberately low. These parameters are meant to be calibrated, not guessed. A flow survey over a few storms is what turns them from assumptions into a model.

After a run, the water balance shows I&I / RDII as its own inflow component, separate from sanitary. That separation is the whole point: you can now state how much of the flow arriving at the works is rain rather than sewage, which is the number a regulator and an investment case both need.